2. For the large rosette: cut 2 - 2 x 12 inch strips of patterned paper and scallop one side. Then pleat (fold back and forth) the pieces about every 1/4 inch. Adhere the two pieces together and then adhere them into a circle.
Using a scrap piece of paper punch out a 2 inch circle. Apply strips of Perma Tac to the circle and then adhere it to the back of the rosette and flatten down the rosette till it adheres to the circle.
For the lace rosette: punch out another 2 inch circle and apply strips of Perma Tac to the circle. Slightly bunch the lace around the outside of the circle to form a 3 inch circle. Hot glue the ends together once your circle is complete.
4. Layer and hot glue each rosette together.
5. Cut a piece of the 3D foam adhesive and adhere to the back of a sticker and place in the center of the flower rosettes.
6. Cut out an 8x10 piece of patterned paper and adhere it to the front of the back side of the shadowbox with Perma Tac
7. Using the Perma Tac adhere a doily towards the upper part of the paper.
8. Using the ribbon adhesive, bunch up a strip of ribbon to create the stem for the flower.
9. Using hot glue attach the layered rosette on to the middle of the doily.
10. Randomly place buttons in the bottom of the shadowbox in front of the grass to hide the hot glue!
11. Place the back on the frame.
12. Using the Slice or another diecutter cut out spring/Easter words on the Accent It All Vinyl. Since the Accent It All has repositionable adhesive on the back I took the backing off the vinyl and stuck it to the Slice cutting board so it wouldn't move around during the cutting. Cut out some spring/Easter words and place them on the outside of the glass over the grass. Using the Perma Tac attach a couple of butterflies to the front of the glass.




























